whistle pig
New member
- Joined
- Apr 26, 2004
- Messages
- 2
- Reaction score
- 0
I have a 68 bronco that the turn signals and brake lights do not work. Brake light switch checks good, any suggestions would be apprectiated.
Electrical Problems
- Thread starter whistle pig
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
STLKIKN
New member
The brake light power goes through the signal switch AFTER the brake light switch.
It sound like you have a faulty signal switch.
You may be able to pull the steering wheel and re-bend the contacts in the switch until the lights work again.
It sound like you have a faulty signal switch.
You may be able to pull the steering wheel and re-bend the contacts in the switch until the lights work again.
S
shane johnson
Guest
What if one brake light works and the other doesn't? Is it possible that it is still faulty in the steering column? Does each brake light come out on different wires? Any help would be appreciated!!
STLKIKN
New member
Provided that your bulbs are good, and that your signal relays are working, then yes, you may still have a signal switch problem.
One way to pin point the switch as your problem (and eliminate any wiring problems)would be to use a jumper wire at the wiring connector coming out of the column to feed power into (I believe) the light green and dark green wires. These should be your signal/ brake from the switch.
One way to pin point the switch as your problem (and eliminate any wiring problems)would be to use a jumper wire at the wiring connector coming out of the column to feed power into (I believe) the light green and dark green wires. These should be your signal/ brake from the switch.
