Latest activity
-
Yo, In the parts diagram, I believe it is for #2 , 1469 Carrier support (aka latch). I have not seen any plastic parts except for... -
Bronconnoisseur replied to the thread Spare tire Carrier.thanks for these suggestions. As I look closer at it i’m tempted to just throw on a fold down tire mount out of my hitch
-
so many choices... * Repair/replace (make sure the metal backing plate is still inside the tail lght bucket'n tailgait. I believe if...
-
JJasgeer replied to the thread First Bronco- have questions.I put the 1-2" lift on the TTB front suspension and was able to run 32-33" tires as I remember. I went to a scrap steel dealer and...
-
Cchrlsful replied to the thread Spare tire Carrier.so many choices... * Repair/replace (make sure the metal backing plate is still inside the tail lght bucket'n tailgait. I believe if...
-
Cchrlsful replied to the thread Transmission fluid help 89 bronco 4spd man.every owner (even if nota wrencher) deserves a manual. Either a fairly useless one that was standard w/ur vehicle back in the day (C...
-
Cchrlsful replied to the thread Leaving the hard top at home.drop windshield 1st (they all do even w/o the 1st 3 yr clip or dash spiners) and havea 'panel & trim" co make 1 up. I do that but pull...
-
Cchrlsful replied to the thread Vin number warranty plate decode information.sure, easy: broncohio site hasa decoder on its frnt page: http://www.broncohio.com/tech/ebvins.html
-
Cchrlsful replied to the thread Auto locking front hubs.yeah, most "go the other way". Dependable, durable, inexpensive (compaired) but I can C ur ideas - convieniance. I'm the same way w/a...
-
Cchrlsful replied to the thread First Bronco- have questions.ID the major components as a 2nd job after cleaning (U may need to do so w/some of these as well - to see #s, castings and stampings)...
-
CCongratulations on your acquisition. I am finishing my son’s 1989 Bronco XLT 5.0L with quad shocks, so I might be able to pass a few...
-
I put a 33 BFG mudterrain on my 1993 rear spare tire carrier. I did not like the way it rode and I was always a little concerned it...
-
miesk5 replied to the thread Spare tire Carrier.Yo, In the parts diagram, I believe it is for #2 , 1469 Carrier support (aka latch). I have not seen any plastic parts except for... -
Ppaul rondelli replied to the thread Spare tire Carrier.I put a 33 BFG mudterrain on my 1993 rear spare tire carrier. I did not like the way it rode and I was always a little concerned it...
-
Rrfarrcr replied to the thread Looking for a front wheel bearing retaining ring.That's the one. Thank you I just may switch to manual hubs.
