bronco II plug fire

[deogolf]

Need help! 86 bronco II. I have fire to the distributor. Distributor and module are new. No fire to the plugs. Two fuel pumps. Both work, but are straight wired to a manual toggle switch. Any suggestions? Thanks

 

[hifooy07]

did you replace the wires? did you replace the whole dristributor or just the cap?

 

[deogolf]

did you replace the wires? did you replace the whole dristributor or just the cap?

hi, thanks for the reply. sorry, haven't had time to work on this vehicle in a while. yes, the whole distributor and module is new. any ideas of what to check next? anybody? thanks.

 

[mauser1111]

I'm having the same problem, but I replaced just about every ignition compnent and now Im on replacing the sensors. I tried replacing the rotor button again and then it fired and ran, bu when It got warmed up it shut off again. I need to replace the EVP sensor on mine agin because it was junk, but Im stumped too.

 

[Seabronc]

I know you said you replaced the ignition module, are you referring to the pick up coil inside the distributor under the rotor? If not, that is a classic symptom of a bad pick up coil. They run fine until the engine warms up and then it is like someone reached over your shoulder and turned off the key.

Good luck,

>-