Tie Rod Flip Inserts

[EvlFaust]

Howdy;

I need a bit of help finding tie rod flip inserts and a reamer tool. I have scoured the net but can not find anything so far. I am putting a 5.5" suspension lift on my 95 Bronco that already has 4.5" in the rear from a shackle flip and 2" up front from a leveling kit. I would like to get a Superlift Steering System but the combined 7.5" goes beyond it's limit. I figure that a tie rod flip would remedy that problem.

Any help would be appreciated.

Thanks.

 

[miesk5]

yo

Reamer size depends on what you TRE kit you use;

for da Reamer SOruce; try

Snap-On R121 is a 7 degree reamer. It's also a cleanup reamer that is really meant to be used by hand to clean up tapers. It is the cheapest option, will last for a dozen + reams when used with a drill and a good cutting fluid, and is close enough to 7.12 to work fine For some reason it's marked wrong usually it's $46.

GOODSON

7 degree taper tie rod reamer

Premium Tapered Reamers

Deburr or enlarge tapered holes

• Use by hand or with a powered driver to deburr or enlarge tapered holes for tie-rod ends or ball joints • Use in 1⁄2" chuck at approximately 40 RPM

&

Ball Joint/Tie Rod Reamer for 1/2" drill.1.5" per foot / 7.15 DegreeOverall length 6.5"Flute length 4.5"Minimum diameter 7/16"Large diameter 1"U.S. MADEPrice: $69.00

Is this what you want to do?

Chevy Part Numbers & pics Source: by Broncoholics at Ford Bronco Zone Forums

Chevy & Tapped DOM Steering Links by WFO Concepts in an 89 Source: by Andrew K (Andy351, das panzer, sloppy seconds, the magic carpet) at SuperMotors.net

This is for a heep, but..

Tie-Rod Flip Kit Installation Instructions 1.The 2044R Tie-Rod ...File Format: PDF/Adobe Acrobat - Quick ViewThe 2044R Tie-Rod Flip Kit includes a. Reamer and a Knuckle Tapered sleeve. Insert.The insert is shown on right and the reamer to be used is on the left........