scottericsonon
New member
- Joined
- Oct 16, 2004
- Messages
- 4
- Reaction score
- 0
hello all
im in the midst of yanking the dead 300 from my 81 bronco and replacing it with a freshly rehabbed 351W
im running into a problem with my clutch linkage
the end of the "Z" bar went to a pivot ball that was attached to the block on my 300 but theres no spot for it to ***** into my 351
does anyone know where i can put my hands on the bracket for it??
does ford still make them?
if so anybody know the part number??
or is this something im going to have to fab for myself???
also does anyone know offhand if car manifolds (80 lincoln town car)will fit a bronco??
or should i just break down and spend the extra bucks on a set of headers??
TIA
scott
im in the midst of yanking the dead 300 from my 81 bronco and replacing it with a freshly rehabbed 351W
im running into a problem with my clutch linkage
the end of the "Z" bar went to a pivot ball that was attached to the block on my 300 but theres no spot for it to ***** into my 351
does anyone know where i can put my hands on the bracket for it??
does ford still make them?
if so anybody know the part number??
or is this something im going to have to fab for myself???
also does anyone know offhand if car manifolds (80 lincoln town car)will fit a bronco??
or should i just break down and spend the extra bucks on a set of headers??
TIA
scott