husmann
Member
Hey ya'll,
I'm getting a rebuilt 5.8L long block for my 1993 Bronco. The engine was actually running fine prior to pulling it, except that it would not keep it's oil pressure up when driving (had about 235k miles). I had no CELs or driveability issues.
When I transfer everything over to my rebuilt engine and put it back in the vehicle, what sensors, valves, sending units should I replace? I'm talking about things like: PCV valve, EGR valve, O2 sensor, TPS sensor, intake air temp sensor, etc.
Thanks,
Husmann
I'm getting a rebuilt 5.8L long block for my 1993 Bronco. The engine was actually running fine prior to pulling it, except that it would not keep it's oil pressure up when driving (had about 235k miles). I had no CELs or driveability issues.
When I transfer everything over to my rebuilt engine and put it back in the vehicle, what sensors, valves, sending units should I replace? I'm talking about things like: PCV valve, EGR valve, O2 sensor, TPS sensor, intake air temp sensor, etc.
Thanks,
Husmann