Broncoholics
Broncoholics
Does anyone have photos of rigs that have raised the trac bar mount on the axle end? I need some ideas before I start.
I'm thinking of using 1/4" thick box tube welded on top of the existing mount.
This should be strong enough but the sideways pressure being up much higher will require some beefing up. I'd just like to see what all you guys have seen or done.
I'd hate to see it break off in a simple roll over out in the boonies!
I'm thinking of using 1/4" thick box tube welded on top of the existing mount.
This should be strong enough but the sideways pressure being up much higher will require some beefing up. I'd just like to see what all you guys have seen or done.
I'd hate to see it break off in a simple roll over out in the boonies!