racrx
New member
So 1990 Bronco XLT 5.8l. new to me, it was sitting for a few years. I cleaned the throttle body, changed out the TPS, map and IAC. Vehicle runs very well but it has no acceleration under load< cant get out of my own way. Checked codes KEEO got a 32, 63. and 67. I believe code 32 is for the egr, code 63 is a memory code which is for the TPS and code 67 also memory code is for the NSS. The first TPS i installed was bad out of the box, replaced. check engine light was on but after replacing the TPS for the second time it is now off. I checked the timing and it was off so i put it at 10 degrees. Still getting the same codes.
The OD off lamp stays lit all the time. Would you get transmission code in KOEO test mode? Any suggestions would be appreciated.
I haven't changed the NSS yet but have the part. It has to be re-pinned.
The OD off lamp stays lit all the time. Would you get transmission code in KOEO test mode? Any suggestions would be appreciated.
I haven't changed the NSS yet but have the part. It has to be re-pinned.