Nice work!
Sounds like you are well on your way
Cheers
We got it back to the mechanics and now they are saying it is going in to closed loop from monitoring the O2 Sensor, but that it is now running too lean! Ugh! They are pointing at the injectors, but have tapped out. They can't find ones that they can say will without a shadow of a doubt, will work. We brought it home and I did some research and ordered in 8 Standard motor FJ712 after seeing it listed on multiple sites for a proper fit and flow rate. It will start and idle smooth as can be, and if you barely touch the gas pedal it will go, but as soon as you try to accelerate it feels like, well for a lack of better terms, something is holding it back, worse than before. Other than setting the timing back to 10 degs they didn't do anything else other than check to make sure it is going in to closed loop. I tried to set the timing back with the vacuum gauge and it would barely idle. TPS, MAP and IAC have all been re-replaced. The IAC did help, but not much. My son drove it last night after replacing and clearing memory and he said it ran great, until he shut it off at the gas station to put fuel in it, then on the way home it was back to poo. Maybe it's time to try that other distributor... IDK. There are no KOEO codes and the only code I got with a KOER was a Knock sensor, which it does have and I haven't changed it, but from what I found that shouldn't cause this kind of issue. There are 0 vacuum leaks, I bypassed the EGR with no improvement, and fuel pressure is steady and not losing pressure after 30+ minutes of being off. Any other ideas are appreciated.
