1986 Bronco 2, 4x4 Eddie B clutch Problem

[Obronco2]

1986 Ford Bronco 2, 5-speed overdrive manual transmission. The clutch is not releasing enough when I push the pedal in, If I let it set a while with the engines shut off, it will release enough once or twice to shift between gears and then quits. It drives fine when I can get it into gear, no slippage.The master cylinder resivour is full of fluid. Could it be just the release bearing (throw-out bearing) that needs replaced, maybe the ***** cylinder ? I've never replaced one of these hydraulic clutches, is it hard, any special tools required to do thework?

Anybody's help would be greatly appreciated.

I'm a Chiefs fan, always have been, always will be. BUT...Go Giants! No team ever caught cheating in a season should be able to play in a SuperBowl!!!

 

[FORDPLAY]

***** cylinder ....its prob bleeding off...get a new one its easyer to do that thin a cluch....no thay are thay same as doing any cluch..

 

[andre]

u have master clutch cyl and ***** cyl

check inside of truck folow clutch rod look master clutch cyl is leaking

that can b replace easy just a lock pin

***** cyl tranny must come out

some time when master worn **** in air and lose pressure

G L

 

[Obronco2]

u have master clutch cyl and ***** cylcheck inside of truck folow clutch rod look master clutch cyl is leaking

that can b replace easy just a lock pin

***** cyl tranny must come out

some time when master worn **** in air and lose pressure

G L

Taking the xtra minutes to reply to my problems is GREATLY APPRECIATED.

May the both of you recieve twice the payback in some form of good.

I have not yet got under the bronco to look at what you talk about but I will when the weather allows (COLD and WET ) and I'll reply back as to what I find, probably with more questions.

Anybody else have any idea's, please add.

Thanks again.

 

[agzmdv]

Taking the xtra minutes to reply to my problems is GREATLY APPRECIATED.May the both of you recieve twice the payback in some form of good.

I have not yet got under the bronco to look at what you talk about but I will when the weather allows (COLD and WET ) and I'll reply back as to what I find, probably with more questions.

Anybody else have any idea's, please add.

Thanks again.

Will be taking on this project this weekend. Clutch Kit, Master and ***** Cyl, etc.