broncolovernewmexico
New member
:-B Man-o-man am I confused.....My wife's 88 bronco XLT, 302,5.0,V8,EFI stalls when she has to turn a corner or even when she has to stop at a stop light-sign.
Only when she has to let go of the accelarator not while driving. But, there is also a delay when she hits the gas pedal to accelerate after being stopped.
I have already pulled the codes in two different steps with my EEC IV.
EOIO : codes 54 & 32
32= EGR pressuer feedback
54=Intake air charge temp. sendor circut open:vane air flow sensor out of range
EO : Codes all r codes 21 , 44 , 77 , 52
21=cooling temp. out of range or ECT out of range
44= Thermactor air system fault
77= Operator error during Dynamic Response Test/Wide Open Trottle not sensed
52= Power Steering pressure switch open.
These are the codes. Now, the problem started about 3-4 months ago. I went ahead and changed the plugs, wires, Dist. Cap, Router cap and put a new Fuel filter on it. (I was tunning my Bronco so I bought everything twice.) I thought this would fix the problem but it didn't.
I wanted to post this to see if anyone had any other ideas. I will look into my Manuel to check where everything is and see if I can do it today.
If you have any better ideas, let me know.
thanks a bunch!!!!!
Only when she has to let go of the accelarator not while driving. But, there is also a delay when she hits the gas pedal to accelerate after being stopped.
I have already pulled the codes in two different steps with my EEC IV.
EOIO : codes 54 & 32
32= EGR pressuer feedback
54=Intake air charge temp. sendor circut open:vane air flow sensor out of range
EO : Codes all r codes 21 , 44 , 77 , 52
21=cooling temp. out of range or ECT out of range
44= Thermactor air system fault
77= Operator error during Dynamic Response Test/Wide Open Trottle not sensed
52= Power Steering pressure switch open.
These are the codes. Now, the problem started about 3-4 months ago. I went ahead and changed the plugs, wires, Dist. Cap, Router cap and put a new Fuel filter on it. (I was tunning my Bronco so I bought everything twice.) I thought this would fix the problem but it didn't.
I wanted to post this to see if anyone had any other ideas. I will look into my Manuel to check where everything is and see if I can do it today.
If you have any better ideas, let me know.
thanks a bunch!!!!!