Dog pulled out some wires from under the truck

[thornbirdguy]

i parked near the dog one night and it rained, so he went under the truck. the next day i go somewhereand the rear ABS light is on. get back and there are wires where the back of the truck were with teeth marks on them. QUESTION: will reconnecting them with butt-connectors cause to much resistance in the wire and keep the ABS light on, or will it work fine?

 

[Mike @ Tracy]

There have been a couple of times that I had to use connectors on semi's ABS sensors worked fine. Imagine it would on a bronco. I would recomend replacing up to the nearest factory plug when you can though.

 

[Roadkill]

Should work fine, the speed sensor works off of pulses so the minute amount of added resistance should not matter. I aint no genus tho, so I could be rong! It's definately worth a try. Just make sure you seal the connection very well. I suggest heat shink tubing for the best seal.

 

[Justbust1n]

just wrap some electrical tape around them when you get done butting them to keep the water out ... if you got the time and tools you could soder them i think that would keep me from worrieing about them comming lose if i am wheeling hard...

goodluck