Distributor and Rotor Question. Help!

[Treg]

Replacing the distributor, rotor, plugs, and wires on my 93. It is a MSD Rotor and cap. Did not check and mark which way the rotor was pointing when I took it off. Anyone have an idea which way I should point it because I am reading many different opinions googling it. Thank you

 

[Treg]

BTW, It is a 351W. While I am asking specs say plug head spacing is 44. Yes?

 

[miesk5]

Yo Treg,

Sorry, had to do exercises.

Timing Adjustment on a 302 or 351 by sackman @

http://www.fullsizebronco.com/forum/23-technical-write-ups/168214-how-properly-set-timing-302-351-a.html

...

Spark Plug Gap 0.044

Ignition Timing (deg) MT 10B

Ignition Timing (deg) AT 10B

Fuel Pump Pressure (psi) 35-45

Idle Speed (rpm) MT 775

Idle Speed (rpm) AT 675

by Auto Repair Reference Center

 

[Bully Bob]

If I read this right.., the rotor fits in a "notch" & only goes/locks in place in one spot.

Unless you're saying you pulled the whole dizzy out of the block.

"it is a MSD Rotor and cap"

    (no mention of dizzy here)