Body Lift problems

[gnarly_bronco_kid]

I put a three inch body lift on my 96 broco with the t5 manual tranny and the shift extender that the kit came with is universal and does not work for my bronco.......anyone know where I can get one that will fit? I also need one for my 4x4 shifter.

Thanks Zak

 

[Justbust1n]

broncograveyard should have them ... i mean when i put my 3 inch lift on i didnt have to worry about that they where streched alot but i still had enought left not to worry about it though just call them if you dont see it online

 

[seawalkersee]

What do these extenders look like? I have just been using the same size dia. tubing/stock to lengthen them. I have to do my shifter now, I just put a 435 in place of the C6.

Chris

 

[swampthing]

you can heat and bend the 4x4 shifter

 

[noahsdad]

aNY body lift i have ever seen done or done myself you had to remove the sticks take them down to a shop had them cut and weld that peice of bar stock into the vertical section of the stick. Cost about 30 bucks depending on the welding shop but pick a good one off road is not where you want to find out that joe crap cant weld to save his life.

 

[seawalkersee]

Awww...I will weld it myself. I already lengthened the T-case shifter. But that was when I still was running the C6. Now there is a clearance problem with the shifter in 1 and 2. Not to mention that in reverse, it hits my console...and there is no **** on it yet.

So what do these extenders look like?

Chris