Bllack Relay by EEC-IV

[MDDYATV]

So I am convrting my 84 351w california emissions bronco over to a non computer controlled carb and HEI. as I am pulling out the EEC-IV box there is a relay switch that is attached to the side of it i traced the wires one goes to the starter soleniod one goes to the negative batery post one goes to a another wiring harness plug that is under the hood that my temp and oil gauge wires go to. and the last one went into the EEC. I looked at the wiring diagram and the only thing I can think of is it being the side marker relay. but with it out all my side marker lights work. any idea what this relay may be?

Thanks

MDDYATV

 

[Seabronc]

OK, what you are looking at is the EEC power relay. If the wire colors are as follows, that is what it is: white with light red hash marks, Yellow, red, black with light green dashes. It can come out as well as the EEC.

Good luck,

>-

 

[Seabronc]

Do yourself a favor and invest in an EVTM Electrical and Vacuum Troubleshooting Manual, it is the single most useful document I own. Then comes a complete set of service manuals. You can find them on ebay.

http://cgi.ebay.com/ebaymotors/Ford-Truck-...sspagenameZWD1V

>-

 

[MDDYATV]

Thank you seabronc that is exactly the wires that are attached. I just wanted to make sure. I am installing the carb and hei tomorrow. I cant wait to see how it runs