Long long story short; she starts, runs, warms up, then dies. Go ahead and laugh, but after replacing the coil, amp, distro guts, I found the Ballast bad. The problem is I keep smoken the ballast. I replaced the ballast with a coil specific amp rating (1.35). What I see is 12 volts in the ballast, 6 out when cold. When it hits 12 volt out, the eng dies. I've shot the wires, but all reads right - cant find a short. I have a Centech harness, but believe I've got it wired wrong. My rub, Centech provides a trouble shooting diagram that differs from the installation. Specifically, install shows violet (from ignition sw) to blue (Amp). Trouble shooting shows blue wire to the "S" post on starter solenoid. We've tried both, different problem with troubleshooting diagram; eng turns and fires, but stalls. Anyone have a clue?