Search results

  1. tjg8675

    excessive engine vibration

    Hi All, Well this ones got me stumped... I'm getting excessive engine vibration at idle in park/neutral and throughout the rev range while driving and no koeo or koer codes except the pass code. I thought it might be the crankshaft position sensor but unfortunately I do not have one, which...
  2. tjg8675

    Speedo jumping and hard shifts + ABS light...bad VSS?

    Hi all, Having an issue with my 1995 bronco 5.8l... My speedometer is jumping and showing incorrect speed while driving slow (0-25mph) Above 25 it seems ok. Also ABS light comes on when speedo is jumping & also shifts are hard & not at normal shift points. I'm thinking I have a bad VSS. Hoping...
  3. tjg8675

    Intermittent check engine light

    Hi all, This is for my 95 bronco 5.8l 191,000mi Starting a new thread for this...I have posted about this briefly in a previous unrelated thread and thought it was resolved but apparently that was not the problem... My check engine light issue(s) have returned, I had forgotten to tighten my...
  4. tjg8675

    Steering wheel not straight after steering box replacement

    Hi all, I replaced my steering box yesterday for the 2nd time this year (first box was still loose), I followed the same procedures as the 1st time except this time I had to remove the drag link from the pitman arm and remove the pitman arm from the steering box with the steering box removed...
  5. tjg8675

    Cooling System Issues

    Hi All, I have been having cooling system issues for a while now (years I've been dealing with this), mostly a very erratic temp gauge, to the point I'm scared to go up steep grades and big hills for very long or risk overheating. I mostly stick to flat roads and an occasional hill here and...
  6. tjg8675

    Transfer case swap

    Hi all, I am swapping my transfer case out with a remanufactured t-case and am wondering if I need a gasket betwern the t-case and the adapter to the rear driveshaft? It would be a gasket with 4 holes, if the gasket is required what is the part #? Thanks for the help
  7. tjg8675

    Transfer case fluid confusion

    I just changed my Transfer case fluid and am a little confused with the capacity difference of fluid coming out and going back in... About 1 gallon of fluid came out and only 2 quarts went back in before coming out of the fill plug hole. Could there be an issue with my transfer case input...
  8. tjg8675

    Ignition Issue

    I seem to be having issues with the ignition switch, my guess is the button that the ignition lever in the steering column pushes to start the motor is failing, it works most of the time but sometimes after multiple stops and starts I get a "no start" and have at times resorted to jumping the...
  9. tjg8675

    Two annoying issues

    I have two annoying issues I need help with for my 95 bronco 351w Issue 1 - Serpentine belt chirps when cold, belt chirps when warming up in the morning (not a squeal, definitely a "chirp"). I have noticed wear marks along the edges of the belts that I think is where the chirp is coming from (I...
  10. tjg8675

    Transmission Mount replacement

    Hi All, Just wondering if anyone can help me with the correct procedure for replacing the transmission mount in my 1995 bronco A4OD. I'm just not sure where the safest location to put my floor jack so I don't mess up the transmission, I know it is a easy job but understand that it is a very...
  11. tjg8675

    Oil Leak

    Hi All, I seem to have developed a bit of an oil leak, it used to just drop a drip or two here and there but in the last couple weeks has become a puddle so I'm looking to get it fixed. Not sure if it is my Rear Main Seal or if it might be my oil pan gasket. To me it kinda doesn't look like a...
  12. tjg8675

    Speedo Issues

    Hi All, So my 95 bronco 351w A.T. is starting to show the gremlins and was wondering if anyone has found a end-all be-all solution to eliminate all the junky ford electronic crap (PSOM, ECU, etc.) that seem to just go bad for no reason. I want to keep the 351w for now (because of emissions...
  13. tjg8675

    Serpentine Belt Chirps

    Hi All, In the morning when cold I'm hearing chirping noise from engine bay (sounds like serpentine belt on water pump/fan pulley). The noise gets louder as truck warms up but goes away shortly after thermostat opens. Just looking for some input since not a major issue...yet recently...
  14. tjg8675

    Parking Brake Cable

    My parking brake cable on the passenger side (going into the drum brake) is too short and is rubbing the shock (cable runs in front of shock) and making weird noises over speed bumps and other drop-ins and driveways. Is there an extension available? or does anyone know a quick fix? (not sure...
  15. tjg8675

    Bronco/F-150-250-350 rear bumper panel

    Does anyone know where I can buy a rear bumper panel for my 95 bronco? I want the smooth panel (with the license plate holder/lights so if I take off the rear bumper I can paint it to match
  16. tjg8675

    Water pumps

    Hi all, Just wondering everyone's opinion on water pumps for a 1995 bronco 351w 5.8L Edelbrock 8045       $231.66 Weiand 8210win     $186.95 Milodon 16234        $98.95 Motorcraft PW254  $61.99 (made in china) Bosch #98206 -       can't find Dorman/murray = Chinese made junk The bearing...
  17. tjg8675

    ABS Fuse

    Hi All, My 95 5.8L Bronco does NOT have the ABS fuse in the fuse panel to the left of steering wheel, fuse panel guide says ABS F model only. Does anyone know the location of the ABS fuse for the 95 5.8? I need to disable ABS temporarily until I can get it in the shop next week for various...
  18. tjg8675

    defroster question

    Does anyone know a way to disable the a/c from coming on while in mix mode (air goes to floor and to windshield)?
  19. tjg8675

    Key Fob Programming grey plug location?

    Hi Miesk5 Trying to locate this on my 95 bronco not in location shown in pic black box behind glove box any other known locations for grey plug?
  20. tjg8675

    Help with smog (failed nox)

    Hi all, I have a 95 5.8 bronco I failed my State of California rubber glove test(smog). I failed the nox part of the test 15 mph max allow 683. me 1737 fail 25 mph max allow 585. me 727 fail all other tests pass egr - pass pcv - pass air pump - pass vacuum lines sensors/switches - pass...
Top