wiring ???

[ricks73eb]

ok heres the deal i got ALL the wiring from my 91 mustang in my 77eb and now im looking to wire the original ignition switch.. any1 ever did it this way??

thanx 4 any help

 

[ricks73eb]

...hello anyone....

 

[Seabronc]

Haven't done it, but if the switch has a start and run position, it should work. If you are using a Duraspark ignition you will need the resistance wire that runs from the switch to the coil. If it is a MSD type system you don't need the resistance wire.

Duraspark diagram attached.

Good luck,

>-

 

[ricks73eb]

Haven't done it, but if the switch has a start and run position, it should work. If you are using a Duraspark ignition you will need the resistance wire that runs from the switch to the coil. If it is a MSD type system you don't need the resistance wire.
Duraspark diagram attached.

Good luck,

>-

the switch im using (or want 2 use) is the factory 77 bronco switch and ALL the wiring is from the 91 mustang the ignition is factory 91 mustang.. im also looking at wiring the wipers and turn signals as of right now i.... (this is kinda sad) i have the factory mustang ignition switch ziptied to the colum and the turn signal switch hidden under the dash (the lights wont work without it being hooked up) so far ive got all the lights hooked...

 

[ricks73eb]

how sad is this!!!!!

 

[mattnkc74]

That made my eyes water

 

[ricks73eb]

That made my eyes water

yea im not to proud of it but im working on it .... SLOWLY.. but im working on it "ive been working on my house mostly" damn priorites!