what do i need to run 33's

[wtfdissux]

just became the owner of a set goodyear mtr 33x12.5r15 tires but i only have 2 inches of suspension lift and stock gears in fact the only thing not stock for the drive train is the lift. (and no it is not a block or coil spacer job 7 leaf rear and skyjacker coils)need as much info as possible so i can do while am on vacation hope we get some snow to play in with those on!!

 

[Big_Ford_Bronco48]

[-X Just put a 6inch lift and and a bodu lift and run 38" that would be alright ..

your friend jason

 

[Allcruisen]

I had 33's on both my '84 & my '95 Bronco without any lift and had very little rub {On the radius arm} when the wheel was turned all the way.....

Allcruisen

 

[Seabronc]

I had 33's on both my '84 & my '95 Bronco without any lift and had very little rub {On the radius arm} when the wheel was turned all the way.....
Allcruisen

33828[/snapback]

​

Ditto

>-

 

[wtfdissux]

ok the 33's fit with only the 2inch suspension lift i already had and rub only if i turn to full stops so rather than grind the tires i adjusted the turn stops out about 1/4 inch per side very little differance in steering but no rub.

on a side note my alignment was off quite a bit after the lift with the 31x 10.5's that i had when i put these on and did the alignment it was almost dead nutz not quite sure why or how but it works for me