viperfangs2
New member
Is it possable to run both of my Fuel pumps on a swich on my 86 ford ranger 2.9Lv6 5 speed trans!
If so what would be the best way.
If so what would be the best way.
Running fuel pumps on a switch
- Thread starter viperfangs2
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
BroncoJoe19
Active member
Sure.. but why would you want to?
In fact in reality they already run off of your ignition switch.
OP
OP
viperfangs2
New member
BroncoJoe19
Active member
Your fuel pumps get power through the ignition switch and the inertial safety switch. IMO to try to bypass either, or both of those switches is dangerous. I'll have no part in it.
joe
joe
muddinlate86
New member
yeah im with joe dont do it. if your going to do something like that run an aftermarket pumpfrome holly or something just make sure you run the right presure so you dont run to rich.why would u want to put a toggle switch on any way
OP
OP
viperfangs2
New member
My last truck was wired like this and it ran for like 4 years with no problems anyway i figured it out!!!
OP
OP
viperfangs2
New member
Because I'm very very poor I pay 900 a month for a 1 bed room apartment i make 950 after taxes. I have to hustle money just to get by.
Florida is expensive.
I'm rewiring my truck with extra wiring harnesses I got it to start and work all my lights. I had to start it on start up fluid because I didn't know how i wanted to wire my fuel pumps!
