Replacement for drag link

[Retherford]

I have a '76 Bronco and need to replace the drag link (the ball joint at the pitman arm has gone bad). It's my understanding that the ball joint is built-in to the drag link and can't be replaced. Is there another vehicle, other than another Bronco, that I can pull the drag link from to replace the one on my '76?

 

[Bronc76]

'77 Bronco has the same type of linkage (if you can find one), and I think that the '76-'77 F-150 had the same type of steering linkage at same time

 

[Bully Bob]

Don't think so., but, I was wrong once B/4...... :lol: /emoticons/[email protected] 2x" width="20" height="20" />

Many folks switch out the "Y" set-up for the earlier "T" style. ('66-'75)

Therefore., most EB stores have "good used" linkage on the shelfs.

Price would prob. be close to the bone-yards., & it'll ship to your door.

------ OR ----------

A good time for you to switch over to the earlier style..?? /emoticons/[email protected] 2x" width="20" height="20" />

 

[S_bolt19]

Wild Horses has em new. Tom's might have a used one if you are looking to go the used route.