Rear seat

[walkercreekbronco]

I'm planning on Rhino-Lining the interior of my EB. Before I do I want to weld nuts on the underside of my bed floor for seat mounting. I have two sets of 4 holes in my bed floor for rear seat mounting. I know that my current rear seat is not factory, but I want to use it for now to save $. I want the option of a fold and tumble seat later. I'd like to weld nuts in the factory seat location so that this is a bolt on later. My 2nd set of holes do not match factory seat mounting. Also, I'd like seat belt mounts. Can anyone tell me where the welded nuts need to be, and what size of nuts to use?

 

[Bernie]

I'm planning on Rhino-Lining the interior of my EB. Before I do I want to weld nuts on the underside of my bed floor for seat mounting. I have two sets of 4 holes in my bed floor for rear seat mounting. I know that my current rear seat is not factory, but I want to use it for now to save $. I want the option of a fold and tumble seat later. I'd like to weld nuts in the factory seat location so that this is a bolt on later. My 2nd set of holes do not match factory seat mounting. Also, I'd like seat belt mounts. Can anyone tell me where the welded nuts need to be, and what size of nuts to use?

My 1974 Bronco had the weld nuts for the rear seat and seat belts already there. I just had to dig the sealer and paint out of the holes to install the bolts. Perhaps your's wasn't a "wagon" model?

Bernie