Disc Brake Conversion

[nido]

I am contemplating a Disc brake conversion for my 1974 Bronco. I would like a simple all in one kit conversion that offers the best braking, and a clean installation. Along withh this I need to rebuild or replace a leaky, sloppy power steering box, drag link and tie rod ends, Trac bar bushings and re-pack front wheel bearings. Any suggestions ? :wacko: ( be nice )

 

[S_bolt19]

Any of the kits from the parts warehouses (BC, WH or JBG) are good. I think WH is the only one who sells the front kit, but I know the others sell the rear kit. I bought BC's rear kit and it went on in about an hour. I was lucky, I was building a seperate axle to put under my EB so I didn't have more than a day's down time, but the rear kit is easy. The front, I did the Ch*bby conversion and even it took less than a day to do. But I would say look at WH for the front conversion and BC for the rear. Then go to a junkyard and get you a hydroboost set up. I just bought a 70 EB and it is all manual with drums and driving it vs. my daily driver is like the difference between night and day. I highly recommend doing any disc upgrade!!