Dana 44, 5-Bolt camber shims,

[Bob Smell]

Does anyone know, where Dana 44, six inch OD, 5-bolt camber shims, for a spindle to steering knuckle can be bought? It, is needed for a 1978 Ford Bronco.

I, bought the wrong item, from East Coast Gear Supply. It, has a smaller bolt circle, and it has six holes.

The attached pictures, show the ECGS shim, inside of the six inch bolt circle, on my Bronco.

I, tried the shims from https://www.ebay.com/itm/133928122053, and they don't work either.

 

[muddrivermike]

Dont know why nobody has replied to this. Why dont you just use the offset camber bushing that screws into the top? Those shims súçk.

 

[Bob Smell]

The offset bushings, alter camber, and caster. With the stock Dana 44, the Ford specifications are 1 to 3 degrees positive camber. I, want 1/2 to 1 degree negative camber, and the bushings alone, will not provide that correction.

 

[johnnyreb]

The offset bushings, alter camber, and caster. With the stock Dana 44, the Ford specifications are 1 to 3 degrees positive camber. I, want 1/2 to 1 degree negative camber, and the bushings alone, will not provide that correction.

Try Torque King out of Montana or Green Sales out of Ohio. You can get their contact informatiomn by typeing their name in the address bar / They are both reliable people to do business with. Also Green Sales has people that answers their phone and they are knowledgeable and has a huge inventory or new old stock. While you are at it--watch their videos--you,ll be glad you did.. Good luck.