cleaning her up

[ironranger433]

Sorry I didnt

 

[swampthing]

looks good...only thing is if you used reg floor carpet for the headliner it will sag on you fairly quickly depending on what kind of glue and how much you used...it is heavier then the regular headliner material

 

[boonebronco]

View attachment 6850View attachment 6849View attachment 6848Sorry I didnt take pics before but trust me, it was very nasty. headliner was torn and hanging , the seats were trashed, torn, springs poke ya in the ass, red seats with a tan interior @-) :-&
I dyed the carpet and plastics (this is the first coat, I know it needs 2-3 more), glued carpet to the head liner and had a split bench from a 78F250 super cab redone

tell what you think

Dyed the carpet and plastics with...?????

Very Interested....

Looks Good. What exactly did ya use?

 

[bko4x4er]

i have a question. looking at these pics reminded me.

can you take the rear bench seat out and put it in the front?

i wanted to take the two bucket seats out because they are in bad condition. and my rear seat is good.

 

[ironranger433]

I used duplicolor dye for all, just make sure every thing is super clean before and it should look great

no on the rear bench, I tried..

 

[boonebronco]

New Project!!!! I really hate my blue, but did not know I could feasibly do anything else...

Keep the pics coming as you progress....looks good

 

[zach351]

looks good man but if it were me i would take out the carpet and put some sort of bed liner down but thats just me cause i work a lot out of my truck and end up pulling my buddies out that drive chevy's so the bed liner helps but what u have done looks great so far.. keep up the good work

 

[ms_jetset]

View attachment 6850View attachment 6849View attachment 6848Sorry I didnt

 

[2NDTOUR89]

Any insight on the bench seat??? I think that a bench from an F series would work and it looks like what you have but if you could confirm what kind of seat that is, it would be great...

 

[ironranger433]

Any insight on the bench seat??? I think that a bench from an F series would work and it looks like what you have but if you could confirm what kind of seat that is, it would be great...

I cant say much more than it came from a 78 F250 supercab

 

[2NDTOUR89]

Thanks, it just bolted in the existing holes right???

 

[ironranger433]

Thanks, it just bolted in the existing holes right???

no.. the mounts where it angles down had to be redrilled and bolted, the rear holes where fine. I welded shut the old holes and grinded them flush.