BrentBronco1987
New member
So I replaced my ignition switch and was told to adjust it just tight.. how do I do this.. I dont want to bust the new one open nor do I want to have to tear the steering column back down
Ignition switch adjustment
- Thread starter BrentBronco1987
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I'm assuming that your Bco is a 1987?
When I did my switch in the 1991 I had to install the new switch, line up the rod, install the screws holding it in and move it up and down so the key position lined up with the switch position. Took a few times of trial and error to find the sweet spot. Once I found the sweet spot then I snugged up the screws really good but not super tight.
When I did my switch in the 1991 I had to install the new switch, line up the rod, install the screws holding it in and move it up and down so the key position lined up with the switch position. Took a few times of trial and error to find the sweet spot. Once I found the sweet spot then I snugged up the screws really good but not super tight.
Similar threads
