Search results

Hey guys, I have a 88 302 efi. I want to swap out all the electronic stuff to a carb set up. Is there anything Else I need to do other than unplug the efi, new intake, mount the carb and run fuel line to it?

hey guys, After driving the truck, whenever I put it in park the idle shoots up about 500 rpm. If I goose the gas pedal it comes back down. None of the cables are hanging up, does anyone have any ideas.

What would cause the red engine light to come on. Not the yellowish Check engine the red one next to it. I checked the oil level -it's ok. the coolant level -it's ok, tranny fluid level - it's ok. Any help would be appreciated I couldn't find an answer in either the owner's manual or the Haynes...

Does anyone have a pic to the shifter knob of the transfer case for an 88 fs bronco. I seem to have lost mine and want to buy a replacement but don't remember the shift pattern.

Does anyone know of a good write up with pics on replacing front rotors on an 88 with manual hubs. Thanx

I want to switch from auto to manual. On my visor there is a shift diagram for a 5 spd overdrive tranny as well as the one for my AOD. I'd appreciate any help.

Don't know if anyone cares, but I decided to convert my 88 302 Bronco to a 88 cummins 6bt Bronco. I always wanted a Bronco then after finally getting one I decided I wanted to run bio-diesel to do my part to help the planet. Well what do I do give up my truck, I don't think so. I then went about...

Does anyone know where I can find those fiberglass visors that go on the outside of the truck over the windshield that sometimes have light in them?

can anyone help me identify mt tranny. I thought it was an AOD. I found a website, http://www.badshoeproductions.com/trans.html, that says by the oil pan i see thats it's an AODE/4r70W. But then I found some info at autozone.com that identifies it as a possible c6 because of the crossmember. I...

Hi guys, Can anyone help me Identify the tranny and axle's in my truck from the door jamb sticker? It says tranny code is -" T "and axle code is - "19". Ive tried looking on the internet but couldn't find anything.

Does anyone know how much an 88 stock Full size Bronco weighs? Also the weight of a Ford 302 engine and the weight of a 30 gal. fuel tank. I gonna turn my Bronco into an Electric and need the weights for some calculations.

The first time i go to start the truck each day it takes 5-8 sec of holding the key before it starts. Any time after that is starts quiker. Any suggestions. Also does anyone know where I can get a good OBD 1 reader for a good price, or even the software and cable to run off my laptop?