Search results

  1. Skitter302

    1980 - 95 Bronco Haynes Manual

    I would try to find a electrical and vacuum troubleshooting manual. The wiring is much better in those books.
  2. Skitter302

    Please help

    Sounds like an ignition control module.
  3. Skitter302

    Greetings, fellow Bronco enthusiasts!

    Welcome to the Zone!
  4. Skitter302

    A neighbor of mine is selling his bronco

    I can't believe how high Bronco prices are currently. IF the Body is Damage free, and the interior is complete, a runnning and driving Bronco is worth $10k these days.
  5. Skitter302

    Bushwacker Fender Flares Now Available for 2021-2022 Bronco!

    Still look better then the new Bronco Raptor flares.
  6. Skitter302

    Newbie Here!

    That Bronco looks like it would clean up good.
  7. Skitter302

    What style rim is this

    Positive off set brings the tire closer to the axle (more backspacing) Negative offset pushes the tire out (less back spacing)
  8. Skitter302

    1995 Bronco Heater / Air Fan speeds

    Sounds to me like your resistor kit is unplug'd or damaged. 1987-1997 Ford Bronco and F-Series Truck Blower Motor Resistor Kit https://shop.broncograveyard.com/1987-1997-Ford-Bronco-and-F-Series-Truck-Blower-Motor-Resistor-Kit/productinfo/37217K/
  9. Skitter302

    1989 Ford Bronco

    Take the bolts out of the body side and slip it over the bar and bolt it back down.
  10. Skitter302

    A Few Words to Introduce Ourselves – CARiD – New Supporting Vendor

    Thank You for being a Supporting Vendor for the forums! I do quite a bit of window shopping at CARiD. Great selection to pick from.
  11. Skitter302

    Has anyone use IRIUDIUM SPARK PLUGS.

    MDS had great instuctions on how to wire the box, but in simple, you wire the 12v coil leads into the box wiring and the new output leads go to the coil. Adding the MSD box causes a small delay so you'll notice a drop of 5-7° of timing, Just rotate the dizzy to get your timing back to normal and...
  12. Skitter302

    Has anyone use IRIUDIUM SPARK PLUGS.

    MSD Box helps too. Just check your timing after you install it. I put one on my Centurion and it got those 35"s moving much easier from a stop. Put one on my 300 I6 and it felt like a torque boost.
  13. Skitter302

    Has anyone use IRIUDIUM SPARK PLUGS.

    I have used IRIUDIUM plugs before but in a 2v 4.6. Not in a push rod engine. IMHO I like copper Motorcraft plugs for my Pushrod V8s.
  14. Skitter302

    Hello from Chicago

    Welcome to the Zone! In the Pacific Inland Northwest area dealers are adding $10k to every 4x4 sold.
  15. Skitter302

    Wanting your ideas for a different forum layout.

    the Bricknose trucks have the same thing, 87 and 88 are different from 89-91, Every truck has inner generation differences.
  16. Skitter302

    Wanting your ideas for a different forum layout.

    Looks like some Much needed organization I like it.
  17. Skitter302

    Ford Axle Tag

    Hey guys, I tryed searching on google but couldn't find an answer to this question. I was looking at axle codes on the Vin sticker and was wondering if a 3 digit code was anything special compared to a 2 digit code. For example: This is a 2 digit axle code really easy to look up to know the...
  18. Skitter302

    Wanting your ideas for a different forum layout.

    On mobile its worse. Hard to close the Ads.
  19. Skitter302

    Wanting your ideas for a different forum layout.

    ok, I'm done for the moment, going to bed.
  20. Skitter302

    Wanting your ideas for a different forum layout.

    For the Side bar what about adding B-Days?
Top