Search results

  1. miesk5

    1996 XLT new owner

    Yo Need any more info? Good fortune! Al
  2. miesk5

    Anyone know what these wires hanging from the driver's side dash are for?

    Yo Jim, RABS Codes 2, 4, 5 & 9 (incomplete) Pin-Point Tests in an 88; & Self Test; Click NEXT to view all pages; miesk5 Note; for all Resistance tests, battery needs to be disconnected; remove Negative cable at battery. Give it shot, better than nothing ... & To check the brake system warning...
  3. miesk5

    Anyone know what these wires hanging from the driver's side dash are for?

    Yo Jim, RABS Self Test; except 93-96; "...The 90 service manual gives a routine to pull RABS codes. When the light comes on, don't turn the truck off before reading the codes. Put it in park, chock both front & rear of the wheels, note whether the red brake light is lit also, then momentarily...
  4. miesk5

    Anyone know what these wires hanging from the driver's side dash are for?

    Yo Jim, It's difficult for me to identify the component(s) serviced without wire colors etc. So, here are the 1989 Ford Bronco EVTM, Emissions (yellowish/red book cover) & Pre-Delivery Manuals, Partial via mrnewland1 in Google Drive @ 1989 Service manual - Google Drive Slow scrolling, so...
  5. miesk5

    1990 Bronco

    Yo Diaw, Have you tested for Diagnostic Trouble Codes yet?
  6. miesk5

    Surging/lurking in first gear?

    Yo Bronconnoisseur, Pull the vacuum line off the mod. If fluid comes out of the vacuum line your modulator is no good. Check vacuum line to modulator from engine intake manifold source. See Vacuum Gauge Diagnosis - BEST!; Normal engine; Steady gauge 18"-20" at all speeds..." READ MUCH MORE...
  7. miesk5

    1996 XLT new owner

    Yo Bronconnoisseur, Welcome and congrats on acquiring the best year Bronco! ASAP, find out if speed control recall work, if equipped was completed. If you still have concerns about Recalls, please contact the Ford Customer Relationship Center: US: 800-392-3673 | CA: 800-565-3673 Note: 3673...
  8. miesk5

    William (Bill) Hyatt

    Yo Bill, Welcome!
  9. miesk5

    Fuel Gauge Problem

    Yo KGC, Welcome! Testing in a 96; "...I had the fuel gauge pegs past E blues. Both trucks had gas logged floats..." by wood4 ■ fuel gauge Ground G200 in lower side of passenger side plastic kick panel Section 13-01: Instrument Cluster, Conventional 1996 F-150, F-250, F-350, Bronco...
  10. miesk5

    1990 Bronco

    yo D, Welcome! Try a Self Test for Diagnostic Trouble Codes by my pal, BroncoJoe19 @ Code Reader..... The engine temperature must be greater than 50° F for the Key On Engine Off (KOEO) Self-Test and greater than 180° F for the Key On Engine Running (KOER) Self-Test. Run it around to heat the...
  11. miesk5

    95 c202

    Yo, Sorry, my source has dropped 1994 and earlier Bronco and truck/van wiring diagrams... but the a hats failed to inform me and many businesses of this. Will try to find the 93 F Series info.
  12. miesk5

    95 c202

    Yo J, Welcome! 1995 BRONCO:
  13. miesk5

    won't warm up

    Yo Sinker, Welcome! Following by Ford; "... PINPOINT TEST C: ENGINE DOES NOT REACH NORMAL OPERATING TEMPERATURE C1 CHECK FOR FROZEN FAN CLUTCH Perform fan clutch test as outlined in Component Tests. Did fan clutch pass test? Yes No GO to C2. REPLACE fan clutch. REFER to Cooling Fan Blade...
  14. miesk5

    𝐒𝐞𝐫𝐢𝐨𝐮𝐬𝐥𝐲 𝐰𝐞𝐢𝐫𝐝 𝐢𝐬𝐬𝐮𝐞𝐬, 𝐚𝐧𝐲𝐨𝐧𝐞 𝐠𝐨𝐭 𝐚𝐧𝐲 𝐢𝐝𝐞𝐚𝐬?

    yo, See my Vacuum leak test in post #9 incl jowens126 's HVAC Control Panel info & Mikey350's tests @ https://www.fullsizebronco.com/threads/help-with-dtc-codes-and-idle.206824/
  15. miesk5

    Hello.

    Yo Darkgrey79, Welcome! Here's the 1979 Bronco/F Series Electrical & Vacuum Troubleshooting Manual by Ford via member Ziggy⚠ @ 1979 Ford Bronco Wiring Manual pictures, videos, and sounds | SuperMotors.net It shows Electrical component location, operation, troubleshooting, with wiring and vacuum...
  16. miesk5

    1989 bronco A/C control panal.... BURNT

    To T, If your blower blew on high in every position, a resistor(s) in resistor pack went bad due to age and high current flow. New resistors are available in most parts stores. Location pic in an 83; "...After replacing the muffler, I could hear that the blower would only run at HI speed, so I...
  17. miesk5

    1994 ford bronco wont shift

    Yo Alicia, Welcome! Try a Self Test for Diagnostic Trouble Codes (DTC)s by my pal, BroncoJoe19 Do KOEO test. Post Code(s) here. A helper can assist you by counting the codes. Some use their smart phones to record them. BEWARE OF FAN, BELTS, PULLEYS, HOT HOSES, IGNITION HIGH TENSION WIRES, AND...
  18. miesk5

    1996 Bronco stalls and intermittently won't start - no spark

    Yo Tom, Welcome! See P0320 pinpoint test by Ford @ https://www.broncozone.com/threads/trouble-code-p0320.25371/ I'd address each of your findings here, however I have intermittent internet issues. Will try to BBL A,
  19. miesk5

    1996 ford bronco wont run

    Yo, Trouble Code: P1705 (5.0L V8 VIN N Auto) Transmission Range Sensor Out of Self-Test Range Print this code data Number of Trips to Set Code: 1 Trouble Code Conditions: Key on, KOEO Self Test enabled, and the PCM detected it did not receive a Transmission Range (TR) sensor signal in...
  20. miesk5

    weird wires... :)

    Yo Steve, Voltage; "...a normal battery that is fully charged produces 12.6 volts, not just 12.0 V. (Remember, when measuring battery voltage, everything in the car should be off, or the battery should be disconnected. Voltage measurements are always "no load" measurements unless the battery is...
Top